$inventorcam xyz not ijk$

Model position: Center - The model is centered along the X axis within the stock.Model position: Offset from left side (-X) - Specifies the offset of the stock in the negative X direction.Width (X): - Enter a value to specify the stock width.You are presented with the following options: You can also offset the left and right sides, the back and front sides, and the top and bottom of the stock to better position your model. Round up to nearest: - Specifies the rounding increment for the stock size.Fixed size box mode lets you enter precise XYZ values to specify the width, depth, and height dimensions of your stock.Model position: Offset from bottom (-Z) - Specifies the offset of the stock in the negative Z direction.Model position: Center - The model is centered along the Z axis within the stock.Model position: Offset from top (+Z) - Specifies the offset of the stock in the positive Z direction.Height (Z): - Enter a value to specify the stock height.Model position: Offset from front side (-Y) - Specifies the offset of the stock in the negative Y direction.Model position: Center - The model is centered along the Y axis within the stock.Model position: Offset from back side (+Y) - Specifies the offset of the stock in the positive Y direction.Depth (Y): - Enter a value to specify the stock depth.Model position: Offset from right side (+X) - Specifies the offset of the stock in the positive X direction.Fixed size box mode lets you enter precise XYZ values to specify the width, depth, and height dimensions of your stock.

Inventorcam xyz not ijk